Table of Contents
Advertisement
9. Error Reports
Error reports will be displayed on the device with the
must not be used for diving until the defect-failure is resolved. In order to discover the type of error, proceed as follows:
Quickly press the control button (2) on the control unit body (1). The display (2) will show the error number in the form of this example:
. Digit 2 specifies the type of error-defect.
If the
„FAILURE" icon appears on the display, the device will be disabled and it is not possible to switch it on or off. It must be sent
to the manufacturer for service.
Review of errors as per digit indication:
Calibration error to GROUND ZERO. The range of measured values is too large or the calibration value is out of limits.
Solution: Switch the m
Cutter error. The cutter is incorrectly connected, used or damaged.
Solution: Check the cutter; potentially replace the cutter with a new one.
Low battery voltage.
Solution: If the error appears repeatedly, do not use the device. Contact the dealer, distributor or manufacturer.
Pressure sensor error, or out-of-range value.
Solution: Switch the m
distributor or manufacturer.
If the specified error reports are not successfully resolved or you are not sure how to solve the
problem, contact the dealer, distributor or manufacturer.
„ERROR" icon. If this icon appears on the display of the control unit, the m
off and on, the calibration will be completed again.
2
off and on again. In case of repeated error, do not use the device and contact the dealer,
2
2
31
Advertisement
Table of Contents
