Table of Contents
Advertisement
3. Function
b)
Landing location higher than the take-off location
The m
device must be preset to the positive value for the elevation difference between the take-off and landing location altitudes. The
2
altitude lock in such a case depends on the landing location, i.e. as per version 450m or 900m, plus the specified altitude difference. In
order to provide problem-free functioning and take-off detection ability in such a case, the m
40m above the take-off location and, upon reaching and exceeding this preset altitude of +40m, remaining above this altitude level
until the skydiver´s jump. Upon landing with the preset altitude, the device automatically switches off. Switch on the device prior to the
next dive, i.e. at the take-off altitude of the aircraft. You will be provided with failure free calibration and functioning of the m
Restricted area
+40m / + 130ft
Ground
zero
+450m / + 1475ft
+40m / + 130ft
Restricted area
device requires an ascent up to at least
2
device.
2
7
Advertisement
Table of Contents
