Switching The Device Off; Resetting The Height Of Landing Location - M2 AAD User Manual

6. Control
6.2 Switching the unit off
Quickly press the control button (2) on the control unit body (1). Upon the
for a second time; the
the button for the fourth time. No icon will be displayed. The device is now off. If the switching-off sequence has not been completed,
device will remain in ON mode.
6.3
Resetting the altitude of the landing location
If the landing location is higher or lower than the take-off location, the landing area altitude must be reset. The m
location altitude to be reset within a range of +/- 990m (+/- 2990ft) in steps of 10m (10ft).
6.3.1
Higher located landing location
If the landing location is higher than the location where the device is activated and calibrated, it is necessary to reset the device for the
altitude difference in advance. The m
Example of procedure:
The location of device activation and calibration before diving is at an altitude of 450m above sea level. The planned lan-
ding area after diving is at an altitude of 700m above sea level. The elevation difference is 700 – 450 = plus 250 meters.
Procedure: Switch the device off.
Quickly press the control button (2) on the control unit body (1). Upon the
press the button for a second time, the
icon will be displayed; after a short time, the
fourth time and the digits 0,1,2 ....,8,9 will sequentially show up on the display. Pressing the button upon digit 2 being
Higher located
displayed will preset 200m. Then the digits 0,1,2 ....,8,9 will again be displayed.
landing area
icon will be displayed; immediately press the button for a third time; when the
allows for upward adjustments between +10 to +990 m (+10 to +2990 ft).
2
icon being displayed (3) immediately press the button
icon will be displayed; immediately press the button for a third time, the
. icon will be displayed; Immediately press the button for the
icon is displayed, press
enables the landing
2
icon being displayed (3) immediately
18