M2 AAD User Manual page 15

5. Installation
b)
c)
The thick cable of the control unit is always second and must be
Cable of Control Unit placed on the wound thin cable. If the m
such a way that the thick cable is higher than the thin cable, wind
the cable counter-clockwise from the front view. If the set and devi-
ce are placed in the opposite direction, then it is the reverse.
"Adhere to minimum radius for cable winding r = 25mm!
Bending a strong cable can result in its damage and subsequent
defective function of the m
Both folded cables are secured with the Velcro strap.
Cable of Cutter
Avoid sharp bends, knots, and mutual entanglement of cable while
placing cables.
Cable of Control Unit
"Adhere to minimum radius for cable winding r = 25mm!
Bending a strong cable can result in its damage and subsequent
defective function of the m
Avoid pulling on the cables, particularly the control unit and the
cutter.
device body is placed in
2
!"
2
!"
2
15