Setting Terminal Parameters; Starting The Switch - H3C S6805 Series Installation Manual

Figure3-5 Completing the device driver installation wizard

Setting terminal parameters

To configure and manage the switch through the serial console port or mini USB console port, you
must run a terminal emulator program, TeraTermPro or PuTTY, on your configuration terminal. You
can use the emulator program to connect a network device, a Telnet site, or an SSH site. For more
information about the terminal emulator programs, see the user guides for these programs
Configure the terminal parameters as follows:
Bits per second—9600.
•
• Data bits—8.
• Stop bits—1.
• Parity—None.
Flow control—None.
•

Starting the switch

1. Before powering on the switch, verify that the following requirements are met:
The power cords are correctly connected.

The input power voltage meets the requirement of the switch.

The console cable is correctly connected.

The configuration terminal (a PC, for example) has started, and the parameters are set

correctly.
2.
Power on the switch.
During the startup process, you can access Boot ROM menus to perform tasks such as
software upgrade and file management. The Boot ROM interface and menu options vary by
3-4