Multiframe And Bulk Function Difference - Toshiba teli BU040M Instruction Manual

MultiFrame and Bulk function difference

This section describes the difference between MultiFrame function of AcquisitionMode and Bulk function of
TriggerSequence.
- MultiFrame function sets limits to the number of frames to transfer with AcquisitionFrameCount register.
- Bulk function sets limits to the number of frames to exposure with TriggerAdditionalParameter register.
- MultiFrame function in Normal Shutter mode (TriggerMode = Off)
Camera transfers "AcquisitionFrameCount" frame(s).
AcquisitionMode = MultiFrame
AcquisitionFrameCount = 3
TriggerMode = Off
Start
Acquisition
Command
VD
Exposure
USB Streaming
Copyright © 2018 - 2020 Toshiba Teli Corporation, All rights reserved.
AcquisitionFrameRate
Frame 1 Frame 2
*Exposure overlaps sensor readout.
Frame 1
AcquisitionFrameCount
Stop
Frame 3 Frame 4
Frame 2 Frame 3
173 / 177
Start
Counter is reset.
Frame 1
This exposure is
discarded.
Stream
stops
Frame 1
DAA00195C
https://www.toshiba-teli.co.jp/en/