Appendix; Multiframe And Bulk Function Difference - Toshiba teli BU030 Instruction Manual

MultiFrame and Bulk function difference

This section describes the difference between MultiFrame function of AcquisitionMode and Bulk function of
TriggerSequence.
- MultiFrame function sets limits to the number of frames to transfer with AcquisitionFrameCount register.
- Bulk function sets limits to the number of frames to exposure with TriggerAdditionalParameter register.
- MultiFrame function in Normal Shutter mode (TriggerMode = Off)
Camera transfers "AcquisitionFrameCount" frame(s).
AcquisitionMode = MultiFrame
AcquisitionFrameCount = 3
TriggerMode = Off
Start
Acquisition
Command
VD
Exposure
USB Bus
Copyright © 2013 TOSHIBA TELI CORPORATION, All rights reserved.

Appendix

AcquisitionFrameRate
Frame 1 Frame 2
*Exposure overlaps sensor readout.
Frame 1
AcquisitionFrameCount
Stop
Frame 3 Frame 4
Frame 2 Frame 3
72 / 76
Start
Counter is reset.
Frame 1
This exposure is
discarded.
Stream
stops
D4213050G
www.toshiba-teli.co.jp
Frame 1