Toshiba teli BU040M Instruction Manual page 25

● External trigger input recommended circuit
- Isolated I/F
CAMERA Inside
DC3.3V
10kΩ
- Non-Isolated I/F
CAMERA Inside
DC3.3V
10kΩ
Notes of trigger input cable:
- The recognition of the trigger signal depends on the length, characteristic or driving current of the cable. Therefore
please confirm your system about those conditions.
- Pin 3 is conducted with camera frame.
Using shield cable, terminal processing of the shield is referred as above.
- Please confirm the EMC adaptability in whole of your system.
Copyright © 2018 - 2020 Toshiba Teli Corporation, All rights reserved.
4
3
Camera
GND
4
3
Camera
GND
Your system
Photocoupler
Your
Secondary GND
Your system
Your
FRAME GND
24 / 177
Your
GND
Your
GND
DAA00195C
https://www.toshiba-teli.co.jp/en/