Replace Bearing And Air Gasket - Graco Aluminum Husky 2150 LP Instructions Manual

Replace Bearing and Air Gasket

Tools Required:
• Torque wrench
• 10 mm socket wrench
• Bearing puller
• O-ring pick
• Press, or block and mallet
Service the bearing and air gasket as follows. See F
14–F . 15.
IG
Disassemble Bearing and Air Gasket
NOTE: Do not remove undamaged bearings.
1. Perform the Pressure Relief Procedure, page 12.
2. Remove the manifolds and disassemble the check
valves. See Check Valve Repair, page 16.
3. Remove the fluid covers and diaphragm
assemblies. See Diaphragm Repair, page 18.
4. If necessary, disassemble the air valves. See Air
Valve Repair, page 21.
NOTE: It is not necessary to remove the air valves if
only removing the diaphragm shaft bearing (19).
5. Use an applicable wrench to remove the screws
(25) holding the air covers (23) to the center
housing (1).
6. Remove the air cover gaskets (22). Always replace
with new gaskets.
7. Use a bearing puller to remove the diaphragm shaft
bearings (19), air valve bearings (12) or pilot pin
bearings (15). Do not remove undamaged bearings.
8. If the diaphragm shaft bearings (19) were removed,
reach into the center housing (1) with an o-ring pick
to hook the u-cup packings (402). Remove u-cup
packings from the housing.
9. Inspect parts for wear or damage. Replace as
necessary.
3A8693B
Reassembly
1. If removed, install the shaft u-cup packings (402).
Ensure the lips face out of the housing (1).
2. The bearings (19, 12, and 15) are tapered and can
only be installed one way. Insert the bearings into
the center housing (1), tapered end first. Use a
.
IG
press or a block and rubber mallet to press-fit the
bearing. Ensure the bearing is flush with the surface
of the center housing.
3. If necessary, reassemble the air valve. See
Reassemble Air Valve, page 22.
4. Align the new air cover gasket (22) on the pilot pin
(16) protruding from the center housing (1). Ensure
the pin fits through the proper hole (H) in the gasket.
5. Align the air cover (23) so the pilot pin (16) fits in the
middle hole (M) of the three small holes near the
center of the cover. Install the screws (25) and
hand-tighten.
6. Use an applicable wrench to torque the screws (25)
to 120–150 in-lb (14–17 N•m).
7. Install the diaphragm assemblies and fluid covers.
See Reassemble Diaphragms, page 18.
8. Reassemble the check valves and manifolds. See
Reassemble Check Valves, page 16.
Repair
23