Table of Contents
Advertisement
Clean the intermediate panel on the
Unscrew the retainers on the left and right (Fig. C).
1.
Unfold the retainers on the left and right.
2.
&
Gently lift the intermediate panel and pull it out forwards.
3.
Clean the door panel and intermediate panel with glass
4.
cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Refitting the intermediate panel:
Slide in the intermediate panel as far as it will go (Fig. D).
1.
'
Close the retainers on the left and right and screw them tight.
2.
Refitting the door panel:
Slide in the door panel all the way.
1.
Put the cover back in place and screw it in.
2.
Refit the appliance door.
3.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
Problem
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut
ó
main oven
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen
appliances are working.
Clean the intermediate panel on the
Press the retainer on the intermediate panel on one side and
1.
unlatch it, using a spatula for instance (Fig. C).
Unlatch the other side in the same way and remove the
2.
intermediate panel.
&
Clean the door panel and intermediate panel with glass
3.
cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Refitting the intermediate panel:
Place the intermediate panel in the supports on the left and
1.
right (Fig. D).
Push the intermediate panel downwards in the retainers.
2.
'
Refitting the door panel:
Slide in the door panel all the way.
1.
Put the cover back in place and screw it in.
2.
Refit the appliance door.
3.
Problem
Possible cause Remedy/information
Power cut
0
and zeros
light up in the
display.
The oven does
There is dust on
not heat up.
the contacts.
Error messages
If an error message with
"
message disappears. A time function that has been set is
cleared. If the error message does not disappear, please
contact the after-sales service.
You can take remedial action yourself if the following error
message is displayed.
Error message Possible cause Remedy/information
A button was
"‹‚‚
depressed for
too long or is
covered up.
ò
top oven
Reset the clock.
Turn the control knobs back
and forth several times.
appears, press the
button. The
0
Press all buttons
individually. Check whether
any buttons are jammed,
covered up or soiled.
13
Advertisement
Table of Contents
