Trigger The System; Stop The Melody Sound Only; Noise Abatement Circuit; Anti Car- Jacking - Autopage TRX950 Operation Manual

4.
If the button is not pressed, the alarm will automatically stop after 30
seconds.
N. TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impact will trigger the warn-away signal.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the
ignition key will trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle's starter from
cranking. The siren, horn, parking lights, and dome light will turn on to
alerting of an intrusion for 30 seconds. Then it will stop and automatic reset
and re-arm. If the one of sensors or detectors still active, the alarm system
will sound a maximum of 3 times of 30 seconds cycles.
Door Trigger Trunk/Hood Trigger
Ignition Trigger
NOISE ABATEMENT CIRCUIT: You system has "Noise Abatement Circuit". It
prevents annoying repetitive trigger sequences due to faulty door pin
switches or environmental condition such as thunder, jackhammers airport
noise, etc.
Here's how "Noise Abatement Circuit" works: The alarm triggers 3 times.
Each time, the same sensor or switch is triggering the alarm. "Noise
Abatement Circuit" will interpret this pattern of triggers as false alarm. After
the third trigger, "Noise Abatement Circuit" ignores, or bypasses, that sensor
or switch until the other sensor or switch is trigger.
"Noise Abatement Circuit" covers doors (Hood/Trunk) differently: If the alarm
is triggered by an open door for three full cycles, the doors will be bypassed
until the trigger ceases.
O. ANTI CAR- JACKING
Warning: If you don't need the car jacking function in this alarm system, be
sure to set car jacking feature "OFF". This system is default setting all
car-jacking "OFF".

ACTIVE ANTI CAR JACKING:

Warn-away
Trigger
CLEAR THE FLASH ICON AND MELODY SOUND: While
triggering the alarm the LCD screen will alert user through
melody sound and flashing trigger icon, press the
button 3 times within 3 seconds will clear the flash icon
and stop melody sound on the LCD screen transmitter.
STOP THE MELODY SOUND ONLY: While triggering the
alarm the LCD screen will alert user through melody
sound and flashing trigger icon, press any button on the
LCD remote transmitter to stop melody sound only
18
Shock Sensor
Trigger