Table of Contents
Advertisement
K. VALET MODE:
(System in Disarm or Valet mode)
The valet switch allows you to temporarily bypass all alarm function,
eliminating the need to hand your transmitter to parking attendants or
garage mechanics. When the system is in valet mode, all alarm functions
and remote start functions are bypassed, however the remote panic feature
and remote door locks will remain operational. To use the valet mode, the
system must first be disarmed either by using your remote transmitter, or by
operating the Manual override sequence.
Enter Valet Mode:
1. From the disarmed condition,
turn the ignition to "ON" position.
2. Push and hold valet switch for 2
seconds until the LED turns on.
The LED wills remain on as long
as the system is in 'valet mode'.
Exit Valet Mode:
1.Return to normal operation, turn ignition 'on'.
2.
Push and hold valet switch for 2 seconds, The LED will turn off indicating
the system is exiting the valet mode.
L. CAR LOCATOR
Under armed mode, press the
car locator function. The siren will chirp 6 times.
The parking light will flash 12 times, for you to
easily locate your car.
M. PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the
alarm in case emergency.
1. Press and hold the
will immediately sound.
2. During panic mode, the normal function of this
transmitter button will be disabled. The transmitter
and
buttons can be used to lock and unlock the
door (if the option is installed), however once the
button is pressed, the vehicle's starter disable device,
(where installed) will be disengaged allowing the
vehicle to start.
3. To stop the alarm, press and hold the transmitter
transmitter again for 3 seconds. Also if any transmitter button other than
or
button is pressed and released, the panic mode will be turned
off immediately.
Remote Door Lock
button to active
button for 3 second. The alarm
17
Remote Door Unlock
or
button on the
Advertisement
Table of Contents
