Power On Memory - Autopage TRX950 Operation Manual

Your 5-button remote transmitter can be utilized to control a second vehicle
security system, To program the remote control transmitter to a second
vehicle, follow the instructions for Transmitter programming.
Programming the Transmitter to 2
Enter:
1. Turn the ignition key ON 3 times. (Finishing in the ON position)
2. Press valet switch 2 times, holding in on the 2
long siren chirp. (Release the valet switch)
3. Press the shift button of the Car 2 transmitter.
** LCD transmitter must be put in 2
(See next page)
4. Press the lock button on the transmitter; you will hear 1 siren chirp.
Turn OFF the ignition switch; you will hear 3 long siren chirps to confirm
programming and exit transmitter programming
** For 2-way LCD Display Transmitter:
2nd Car Operation:
1. Press first, within 3 seconds press and hold
buttons at the same time for 2 seconds . Two beeping
sound and the "
screen to indicate the second transceiver pin code is
programmed.
2. While the " " icon is displayed on the LCD screen, you
can remote control and communicate with a second vehicle
security system. It has two short "bi" sounds while pressing
the button of the LCD screen transceiver.
Back to 1st Car Operation:
1. Press first, within 3 seconds press and hold
buttons at the same time for 2 seconds . One long
beeping sound and the "
displayed on the LCD screen indicating the system is back
to the first transceiver pin code.
2. While the "
screen, you can remote control and communicate with the
first vehicle security system. It has one short "bi" sound while
pressing the button of the LCD screen transceiver.
Z. POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to
remember its alarm state if the power is lost and then reconnected
nd
Car
nd
car mode to program for 2
" icon will be displayed on the LCD
" timer icon will be
" timer icon is displayed on the LCD
22
nd
push, you will hear a
nd
car.
and
and