Table of Contents
Advertisement
A. BATTERY REPLACEMENT:
This transmitter uses one (1) 3-volt
lithium ion battery (#CR2032) that is
placed with the (+) side facing upward.
To replace the battery, you will need to
use a small flat blade screwdriver and a
small Philips screwdriver. Remove the
small Philips head screw. Then locate
the small notch on the lower right side of
the transmitter case next to the key ring.
Using the flat blade screwdriver, carefully
pry the top case from the bottom case.
It should snap apart after breaking the
seal. Before removing the battery note
the direction of the positive (+) terminal.
Place the new battery in exactly the same
manner, being careful not to bend or
damage the contact terminal. Snap the
cases back together and then test the
transmitter to insure it arms and disarms
the alarm. Reinstall the Philips screw to
finalize the battery replacement.
5
Advertisement
Table of Contents
