Table of Contents
Advertisement
Enter Valet Mode:
1. From the disarmed condition, turn
the ignition to "ON" position.
2. Push and hold valet switch for 2
seconds until the LED turns on.
The LED wills remain on as long
as the system is in 'valet mode'.
Exit Valet Mode:
1. Return to normal operation, turn ignition 'on'.
2.
Push and hold valet switch for 2 seconds, The LED will turn off indicating
the system is exiting the valet mode.
L. CAR LOCATOR
Under armed mode, press the
car locator function. The siren will chirp 6 times.
The parking light will flash 12 times, for you to
easily locate your car.
M. PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the
alarm in case emergency.
1. Press and hold the
will immediately sound.
2. During panic mode, the normal function of this
transmitter button will be disabled. The transmitter
and
buttons can be used to lock and unlock the
door (if the option is installed), however once the
button is pressed, the vehicle's starter disable device,
(where installed) will be disengaged allowing the vehicle
to start.
3. To stop the alarm, press and hold the transmitter
transmitter again for 3 seconds. Also if any transmitter button other than
or
button is pressed and released, the panic mode will be turned off
immediately.
4.
If the button is not pressed, the alarm will automatically stop after 30
seconds.
N. TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impact will trigger the warn-away signal.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the
ignition key will trigger the programmed sequence.
The starter disable relay (if installed) prevents the vehicle's starter from
cranking. The siren, horn, parking lights, and dome light will turn on to alerting
Remote Door Lock
button to active
button for 3 second. The alarm
17
Remote Door Unlock
or
button on the
Advertisement
Table of Contents
