Telnet/Ssh; Telnet Settings; Ssh Settings - ZyXEL Communications GS1900 Series User Manual

Table 179 Configuration > Management > HTTP/HTTPS > HTTPS (continued)
LABEL
Session Timeout
Re-Generate
Certificate
Apply
Cancel

32.6 TELNET/SSH

32.6.1 TELNET Settings

Use this screen to configure the TELNET settings. Click Configuration > Management > TELNET/SSH > TELNET
to open this screen.
Figure 246 Configuration > Management > TELNET/SSH > TELNET
The following table describes the labels in this screen.
Table 180 Configuration > Management > TELNET/SSH > TELNET
LABEL
TELNET
State
Apply
Cancel

32.6.2 SSH Settings

Use this screen to configure the SSH settings. Click Configuration > Management > TELNET/SSH > SSH to
open this screen.
Figure 247 Configuration > Management > TELNET/SSH > SSH
Chapter 32 Configuration: Management
DESCRIPTION
Enter the session timeout value. The timeout can be between 0 and 86400 minutes.
Click this to renew the HTTPS certificate that is verified by a third-party to create secure HTTPS
connections between your computer and the Switch. This allows you to securely access the
Switch using the Web Configurator.
Note: Re-generating the certificate will cause a network connection reset.
Click Apply to save the changes.
Click Cancel to discard the changes.
DESCRIPTION
You can allow the Switch for remote Telnet access. The administrator uses Telnet from a
computer on a remote network to access the Switch.
• Enable: allow remote Telnet access.
• Disable: do not allow remote Telnet access.
Click Apply to save the changes.
Click Cancel to discard the changes.
GS1900 Series User's Guide
232