Table of Contents
Advertisement
8
i
NOTE
Disabling
the
LED
frame indications will
also affect alarm sig-
nalization.
i
NOTE
Resetting the device is
not the recommend-
ed way of removing
the device from the
Z-Wave network. use
reset procedure only
if the primary con-
troller is missing or
inoperable.
Certain
device removal can
be achieved by the
procedure of remov-
ing described in "Add-
ing the device" on
page 5.
OPERATInG ThE DEvICE
Disabling visual indicator:
visual indication frame may be turned off for status signaling (turned
On/OFF, power consumption). That means each status change will
be signaled by a short white blink of the frame. Disabling it will not
change operation of the device. To disable the LED frame:
1. Insert the Wall Plug in a socket.
2. Press and hold the button for about 3 seconds.
3. Release the button after LED frame starts pulsing white.
To restore visual indications perform above procedure again.
Controlling the Wall Plug with FIBARO Home Center controller:
The Wall Plug after successful adding is represented in the
home Center interface with two icons. Device allows to turn on and
off the device and displays current active power and cumulative en-
ergy consumption.
Resetting the device to factory defaults:
Reset procedure allows to restore the device back to its factory set-
tings, which means all information about the Z-Wave controller and
user configuration will be deleted.
1. Make sure the device is powered.
2. Press and hold the button.
3. Wait for the LED frame to glow yellow (3rd menu position).
4. Release the button.
5. Click the button once to confirm selection.
6. After few seconds the device will restart with factory settings,
which is signaled with the red frame color.
Advertisement
Table of Contents
