Pointing stick module
Table 6-9
Pointing stick module description and part number
Description
Pointing stick module (includes buttons, board, and bracket)
Before removing the pointing stick module, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the pointing stick module:
1.
Disconnect the pointing stick module cable from the ZIF connector on the touchpad (1).
2.
Remove the four Phillips M2.0 × 2.0 screws (2) that secure the module to the computer, and then
remove the module from the computer (3).
Reverse this procedure to install the pointing stick module.
56
Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page
44).
32).
32).
Spare part number
L16643-001