Advertisement
Section
4
1. Finish filling the pool
a.
Turn off the vacuum and carefully remove it from
the pool.
b.
Fill the pool with water to 2" (5cm) below the
lowest opening. Make sure you remove any creases
from the liner in the bottom of the pool before the
water level gets too high.
c.
While the pool is filling, remove the nails that were
holding the bottom rails in place.
d.
Your pool is now installed. You must now install the
filter and pump, the skimmer and water return inlet.
Please follow the installation instructions that come
with these products.
Important Note:
Before making any openings in the liner, fill the pool
with 60cm (24") of water to stretch the liner fully. When
filling your pool, begin with a garden hose until there
is about 30cm (12") of water in the pool. This will allow
the liner to stretch gradually. You can then use a heavier
flow to finish filling it up.
IMPORTANT:
Make sure that your pool is round, do not assume that by filling up the pool that this will help the pool to place
itself into a perfect round circle. Ensure that it is round before filling up the pool with water.
IMPORTANT SAFETY INFORMATION:
Please refer to the safety page at the beginning of this instruction manual. You must follow the rules and
information regarding placement of safety stickers on your pool.
4-6
No Diving or Jumping. Observe all Safety Rules
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL FRAME
D. FILL YOUR POOL WITH WATER
Advertisement
