Advertisement
Section
Section
3
3
3. Join the ends of the pool wall
a.
Line up the holes in the two ends of the pool wall.
(Image 5)
b.
Now that you have installed the wall you can be
faced with three scenarios.
1) The wall joints align perfectly, if so, move on to
the next step (c).
2) Your wall appears to be too short. It is not.
However the space between the bottom rails must
be decreased by lightly tapping the bottom plates
towards the inside of the pool. You can also tap the
wall lightly with both hands in the desired direction.
(Image 6)
You MUST recheck the gaps at each and every one
of the bottom rails so that they are all equal in gap
size.
3) Your wall appears too long. It is not. However the
space between the bottom rails must be increased
by tapping the bottom plates lightly towards the
outside of the pool or by tapping the wall with both
hands in the desired direction.
You MUST recheck the gaps at each and every one
of the bottom rails so that they are all equal in gap
size.
Important Note:
Bottom rails must always be held in place in the bottom
plate.
Important Note:
You MUST recheck the gaps at each and every one of
the bottom rails so that they are all equal in gap size.
GENERAL INSTRUCTIONS - ROUND POOLS
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL WALL
ASSEMBLING THE POOL WALL
A. CONT. SETTING UP THE POOL WALL
(Image 7)
5
6
7
No Diving or Jumping. Observe all Safety Rules
Steel
Resin
Steel
Resin
3-3
Advertisement
