Advertisement
Section
4
1. Install stabilizers and top plates
NOTE: Depending on your pool model you may have
steel or resin stabilizer and top plates.
a.
Install the stabilizer on the wall while ensuring to
leave a gap between each end. Insert the stabilizer
into either side of the top plate.
Steel:
Image 9
Resin:
Image 11
b.
Position stabilizers and top plates just assembled
on top of wall by slightly tapping them with a
mallet. Make sure the recessed portion of the top
plates lie to the inside of the uprights.
c.
Ensure that the upright is level.
d.
Attach the upright to the top plate using screws
(Steel-V12x34/Resin 2PPS101).
Steel:
Image 10
Resin:
Image 12
Repeat until you have installed all the stabilizers
and top plates.
12
Important Note:
Ensure to leave a gap between the two stabilizers.
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL FRAME
B. INSTALLATION OF THE STABILIZERS AND TOP PLATES
9
10
11
No Diving or Jumping. Observe all Safety Rules
4-3
Advertisement
