Advertisement
Section
3
2-2. For BEADLOCK/SNAPBEAD LINER ONLY
(Please see step 2-1. or 2-3. for other liner)
a.
With a snap bead liner you will not use the plastic
coping strips that are packed in the parts carton of
many pools. You can discard those pieces (if they
are included). Instead, you should have received a
beaded liner track (referred to as a "coping bead
receiver" in
Image 19
b.
The beaded liner track should be installed onto
the pool wall all of the way around the pool. These
pieces should be as close together as possible.
Leaving spaces between bead tracks can cause
liner problems later on.
c.
Once all of the beaded liner track is on the wall, you
can snap the liner bead into the beaded liner track
at four random points around the pool. After that
is done, and you are satisfied with how the liner is
situated within the pool, you can continue snapping
the remainder of the liner into place around the
pool.
d.
Go around the entire pool again making certain
that the liner is securely snapped into the track.
This is important to confirm so that the liner does
not pull out while under the pressure of being filled
with water.
NOTE: Some liners may fit very tightly, it is better to
install uprights, top plate and rail before going onto
next step. See Section 4.
3. Proceed to Section 4 -
Installing the Pool Frame
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL WALL
C. CONT. INSTALL THE POOL LINER
).
19
No Diving or Jumping. Observe all Safety Rules
3-9
Advertisement
