P104 Pressure Unit On Display; P105 Output: 4-20 Ma Or 20-4 Ma; P106 Damping Adjustment - KLAY-INSTRUMENTS 2000 Series Instruction Manual

Intelligent pressure- and level transmitters
Hide thumbs Also See for 2000 Series:
Table of Contents

Advertisement

Instruction Manual Series 2000 HART
ADJUSTMENT PRESSURE UNIT ON DISPLAY (See Conversion table)
P104
Several engineering units can be shown on the display by using a conversion factor.
(See conversion table below). As standard the pressure unit of the transmitter is set to bar. Four
engineering units can be used for displaying the applied pressure on the display (mH2O,
inH2O, bar and PSI).
1. Press [PROG] until "100" appears on the display.
2. Push 4x
3. Now press [PROG] to confirm this.
4. Now press
conversion table below. The number in brackets, see Display column,
represents the menu options of transmitters with other software. Example:
3 = bar
5. Then press [PROG] again to confirm. The transmitter is now set to read in
"bar".
Conversion table:
To show one of the engineering units, P109 must be adjusted at 1 (= Pressure unit).
*)
Pressure units that can be shown on the display. When the value of the highest range is larger
than 9999, "NA" will appear in the display (Not Applicable). Another unit must be chosen.
REVERSE OUTPUT (20 - 4 mA)
P105
The transmitter as standard is adjusted to 4-20 mA output.
Push on [PROG] and go to P105.
Push once at [] to change the output to 20-4 mA (Reverse output).
Push at [PROG] to confirm this.
Now the transmitter will give 20 mA at atmospheric pressure.
ADJUSTMENT DAMPING (0 ... 25 sec)
P106
In P106 an electronic damping can be adjusted between 0 and 25 seconds.
This can be done with the push buttons [] (up) and [] (down).
Always confirm by pushing once at [PROG].
INDICATION OF PROCESS TEMPERATURE (READ OUT ON DISPLAY)
P107
1.
Push [PROG] until "100" is shown on the display.
2.
Push 7 times at [], go to [P107].
H/US/2000-HART/05-2021/07
[]
to get to point P104 (pressure unit setting).
[]
[]
or
and set it to the correct pressure unit. See also the
DISPLAY:
mH2O (mWK) * (1)
mmH2O (mm WK) (2)
bar * (3)
Mbar (4)
PSI * (5)
Atm (6)
KPa (7)
MPa (8)
Kgf/cm2 (9)
mm HG (10)
inH20 ("WK) * (11)
"HG (12)
CONVERSIE FACTOR:
1.000
1000
0.09806
98.0665
1.4223
0.0967
9.80665
0.009807
0.1
73.556
39.37
2.895906
Klay Instruments
Page 14

Advertisement

Table of Contents
loading

This manual is also suitable for:

2000-san seriesCer-2000 series2000-hydrobar series

Table of Contents