Starting The Device - H3C WX2510H Installation Manual

•
The grounding cable is connected correctly.
•
The console cable and power cord are correctly connected.

Starting the device

Power on the device. The device initializes its memory and runs the BootWare. The following
1.
information appears on the terminal screen:
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU
Booting Normal Extend BootWare
***************************************************************************
*
*
*
***************************************************************************
Copyright (c) 2004-2017 New H3C Technologies Co., Ltd.
BootWare Validating...
Press Ctrl+B to access EXTENDED-BOOTWARE MENU...
Press Ctrl + B at the prompt within 4 seconds to access the Boot menu. Otherwise, the system
2.
enters the system image file reading and self-compressing process.
To access the Boot menu after the system enters the system image file reading and
self-compressing process, restart the device.
Loading the main image files...
Loading file flash:/wx2510h-cmw710-system-e5107.bin.........................
...........................Done.
Loading file flash:/wx2510h-cmw710-boot-e5107.bin...........................
...................................................Done.
Image file flash:/wx2510h-cmw710-boot-e5107.bin is self-decompressing.......
...............................Done.
System image is starting...
...
Line con0 is available.
Press ENTER to get started.
Press Enter at the prompt, and you can configure the device when the prompt <H3C> appears.
3.
During the startup process, the CPLD is automatically upgraded to the most recent version.
H3C WX2510H BootWare, Version 1.02
9
*
*
*