Appendix B Leds - H3C WX2510H Installation Manual

Appendix B LEDs

Figure 9 Front panel LEDs
(1) 100/1000Base-T PoE+ autosensing Ethernet copper port status LEDs
(2) PoE+ system status LED
Table 10 LED description
LED
100/1000Base-T
PoE+ autosensing
Ethernet copper port
status LED
PoE+ system status
PoE
System status LED
Mark Status
Steady green
Flashing green
N/A Steady yellow
Flashing yellow
Off
Steady on
PoE Flashing
Off
Flashing green (0.5 Hz)
Flashing green (4 Hz)
SYS
Steady red
Off
18
(3) System status LED
Description
A 1000 Mbps link is present on the port.
The port is receiving or transmitting data at
1000 Mbps.
A 100 Mbps link is present on the port.
The port is receiving or transmitting data at 100
Mbps.
No link is present on the port.
A PoE+ port is outputting power correctly.
A PoE+ port is outputting power incorrectly or is
overloaded.
The PoE+ ports are not outputting power.
The system is operating correctly.
The system is starting up.
The system has failed POST or a serious fault
has occurred.
The system is powered off or a power failure
has occurred.