Starting The Device - H3C WX1800H Series Installation Manual

Starting the device

The following procedure uses the WX1804H-PWR access controller as an example.
To start the device:
1. Power on the device. The device initializes its memory and runs the BootWare image. The
following information appears on the terminal screen:
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU...
Booting Normal Extended BootWare
Press Ctrl+T to start heavy memory test
****************************************************************************
*
*
*
****************************************************************************
Copyright (c) 2004-2020 New H3C Technologies Co., Ltd.
Compiled Date
CPU Type
Memory Type
Memory Size
Memory Speed
BootWare Size
Flash Size
CPLD Version
PCB Version
BootWare Validating...
Press Ctrl+B to access EXTENDED-BOOTWARE MENU...
2. Press Ctrl + B at the prompt within 4 seconds to access the BootWare menu.
To access the BootWare menu after the system enters the system image file reading and
self-compressing process, restart the device.
Loading the main image files...
Loading file flash:/system.bin..............................................
......Done.
Loading file flash:/boot.bin.........Done.
Image file flash:/boot.bin is self-decompressing............................
...........................Done.
System image is starting...
............
Line con0 is available.
Press ENTER to get started.
H3C WX1804H-PWR BootWare, Version 1.06
: Mar 10 2018
: 1000MHz Multi-core Processor
: DDR3 SDRAM
: 1024MB
: 1333MHz
: 768KB
: 1024MB
: 002
: Ver.A
2-13
*
*
*