Installation Sequence - RADEMACHER 9499 Instruction Manual

i

8.1 Installation sequence

1.
Remove the protective caps from
the wall bracket.
2.
Loosen the fulcrum screw slightly
and push down on the sensor
housing.
3.
Mark the drill holes and drill the
holes with an 8 mm drill bit.
4.
Install the DuoFern Sun/Wind
Sensor with the wall plugs and
screws provided.
5.
Then align the sensor housing
horizontally and secure it with the
fulcrum screw.
◆ The solar cell must point
upwards.
◆ The wind propeller must point
downwards.
6.
Finally, push the protective caps
onto the wall bracket.
8 mm
Align horizontally
EN
15