Table of Contents
Advertisement
4 Mechanical installation
4.2.10
Checking and adjusting the belt tension
a Loosen the fixing screw (32) without removing it.
b Screw the adjustment screw (33) to its outmost position.
c Tension the tooth belt (18) by pulling the tension wheel assembly (15) by hand. Tighten the
screws (12) with a torque of 6 Nm.
d Tighten the adjustment screw (33) until there is a gap of approx. 1-2 mm between the lock nut
(34) and the bracket according to illustration below, but not further. Be sure not to overtighten.
e Retighten the fixing screw (32) with a torque of 10 Nm.
Note! Do not make any adjustment on the lock nut (34).
100
34
2
1-2 mm
33
Issue 2020-09-28
M5x10 (2x)
12
18
31
2
Beam
12
Screw
15
Tension wheel assembly
18
Tooth belt
31
Tension wheel
32
Fixing screw
33
Adjustment screw
34
Lock nut
15
32
1019202-DIen-3.0
Advertisement
Table of Contents
