Positioning The Cooker; Moving The Cooker - Rangemaster Professional+ FX 90 Induction User's Manual & Installation Instructions

Fig. 7.1
75 mm min
Fig. 7.2
check cookerhood instructions for actual dimensions
Wall
410 mm min
75 mm min
5 mm
Height to Hotplate
905 mm min
930 mm max
ArtNo.110-0004 - 110 Cooker min spacings
Check the appliance is electrically safe when you have finished.
650 mm min 75 mm min
Height to
Hotplate
905 mm
Height to Flue Trim
min
905 mm min
930 mm
930 mm max
max
910 mm
650 mm min
410 mm min
75 mm min
900 mm
5 mm
Height to Flue Trim
905 mm min
930 mm max
INSTALLATION

Positioning the cooker

The diagrams show the minimum recommended distance
from the cooker to nearby surfaces (Fig. 7.1 and Fig. 7.2).
The cooker should not be placed on a base.
Fig. 7.1 and Fig. 7.2 Cookers installed into recess: The cooker
must have side clearance ABOVE hob level of 75mm up to a
height of 410mm. This can be reduced to 25mm if the surface
of the side wall is non-combustible.
A minimum space of 650 mm is required between the top of
the hotplate and a horizontal combustible surface.
*Any cookerhood should be installed in accordance with the
hood manufacturer's instructions.
**Any splashback must be fitted in accordance with the
manufacturers instructions. Allowance should be made for
the additional height of the flue trim, which is fitted to the
cooker hob.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant. Certain
Wall
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration. We cannot accept
responsibility for damage caused by normal use of the
cooker to any material that de-laminates or discolours at
temperatures less than 65 °C above room temperature.
If a flush fit is required, fit the cooker up to the unit at one
side then fit the unit the other side.
DO NOT box the cooker in – it must be possible to move the
cooker in and out for cleaning and servicing.
If the cooker is not installed between units, a side panel
extension that closes the gap to the wall at the rear is
available as an optional extra kit.

Moving the cooker

On no account try and move the cooker while it is
n
plugged into the electricity supply.
The cooker is very heavy, so take great care.
n
We recommend two people manoeuvre the cooker. Make
sure that the floor covering is firmly fixed, or removed to
prevent it being disturbed when moving the cooker around.
To help you, there are two levelling rollers at the back and
two screw-down levelling feet at the front.
25