Table of Contents
Advertisement
16.7 SYSTEM CONFIGURATION SATURNO
AIR STOVE PRINCIPLE DIAGRAMS
The following diagrams are to be used only as a guideline. For proper connection, always fol-
low the notes of the plumbing and heating installer. The plumbing system must meet local,
regional, or national regulations in force. Installation and verification of operation is to be
performed only by specialised, authorised personnel. The manufacturer will not be held liable
for non-compliance with the provisions listed above.
Upon installation, the product must be set according to the type of system, selecting the appropriate parameter in the "SETTINGS" menu.
The possible configurations are 5, as described below:
CONFIGURATION DESCRIPTION
Room temperature management via probe on the stove or by enabling an external room thermostat
1
FACTORY CONFIGURATION.
Room temperature management via probe on the stove or by enabling an external room thermostat;
3
boiler DHW production with ntc probe (10 kΩ ß3435).
4
External Puffer management controlled by thermostat.
5
External Puffer management controlled by ntc probe (10 kΩ ß3435).
FACTORY CONFIGURATION 1
SATURNO
Fig. 24 - 1°ST CONFIGURATION
29
Advertisement
Table of Contents
