Page 1
This document contains proprietary technical information which is the property of NETVOX Technology. It shall be maintained in strict confidence and shall not be disclosed to other parties, in whole or in part, without written permission of NETVOX Technology. The specifications are subject to change without prior notice.
Table of Content 1. Introduction ....................................... 2 2. Appearance ......................................2 3. Main Features ....................................3 4. Set up Instruction ....................................3 5. Data Report ....................................... 4 6. PIR Detection ....................................7 7. Installation ......................................7 8. Important Maintenance Instruction ..............................8...
R718PQ is a long-range Wireless Short-Range Occupancy Sensor for Netvox Class A type devices based on LoRaWAN open protocol. If there is to be a person or animal movement detected by the R718PQ within the monitoring area, the device reports the detected status to gateway.
Low power consumption and long battery life Note: Battery life is determined by the sensor reporting frequency and other variables, please refer to http://www.netvox.com.tw/electric/electric_calc.html. On this website, users can find battery life time for varied models at different configurations. 4. Set up Instruction...
1. The data transmission period of the device is subject to the programming configuration before shipment. 2. The interval between two reports must be the MinTime 3. The data parsing reported by the device is referenced by the Netvox LoRaWAN Application Command document and http://www.netvox.com.cn:8888/page/index...
Page 7
Example#1 based on MinTime = 1 Hour, MaxTime= 1 Hour, Reportable Change i.e. BatteryVoltageChange=0.1V MaxTime MaxTime leeping(MinTime) leeping(MinTime) Wakes up and collects data Wakes up and collects data Wakes up and collects data REPORTS 3.6V REPORTS 3.5V REPORTS 3.6V Note: MaxTime=MinTime. Data will only be report according to MaxTime (MinTime) duration regardless BtteryVoltageChange value. Example#2 based on MinTime = 15 Minutes, MaxTime= 1 Hour, Reportable Change i.e.
6. PIR Detection If there is to be a person or animal movement detected by the R718PQ within the monitoring area, the device reports the detected Occupy status = 1 along with other sensor status value. If there were no movement detected within the monitoring area within the following 5 minutes IRDetectionTime (Default 5 minutes, configurable), then the device reports Vacant status = 0 along with other sensor status value.
8.Important Maintenance Instruction Your device is a product of superior design and craftsmanship and should be used with care. The following suggestions will help you use the warranty service effectively. • Keep the equipment dry. Rain, moisture, and various liquids or moisture may contain minerals that can corrode electronic circuits. In case the device is wet, please dry it completely.