Advertisement
Quick Links
Model：R718PQA
Wireless Occupancy and Door Sensor
Wireless Occupancy and Door Sensor
R718PQA
User Manual
Copyright©Netvox Technology Co., Ltd.
This document contains proprietary technical information which is the property of NETVOX Technology. It shall be maintained
in strict confidence and shall not be disclosed to other parties, in whole or in part, without written permission of NETVOX
Technology. The specifications are subject to change without prior notice.
Advertisement
Related Manuals for netvox R718PQA
Summary of Contents for netvox R718PQA
- Page 1 This document contains proprietary technical information which is the property of NETVOX Technology. It shall be maintained in strict confidence and shall not be disclosed to other parties, in whole or in part, without written permission of NETVOX Technology. The specifications are subject to change without prior notice.
-
Page 2: Table Of Contents
Table of Content 1. Introduction ....................................... 2 2. Appearance ......................................2 3. Main Features ....................................2 4.Set up Instruction ....................................3 5. Data Report ....................................... 4 6. Disabletime and Detectiontime ................................ 6 7. Installation ......................................6 8.Important Maintenance Instruction ..............................7... -
Page 3: Introduction
Introduction R718PQA is a long-range wireless occupancy and door sensor for Netvox Class A type devices based on LoRaWAN open protocol. LoRa Wireless Technology: LoRa is a wireless communication technology dedicated to long distance and low power consumption. Compared with other communication methods, LoRa spread spectrum modulation method greatly increases to expand the communication distance. -
Page 4: Set Up Instruction
4. Set up Instruction On/Off Power on Insert batteries. (users may need a flat blade screwdriver to open) Turn on Press and hold the function key for 3 seconds till the green indicator flashes once. Turn off (Restore to factory setting) Press and hold the function key for 5 seconds till green indicator flashes for 20 times. Power off Remove Batteries. -
Page 5: Data Report
The data transmission period of the device is subject to the programming configuration before shipment. The interval between two reports must be the mintime The data parsing reported by the device is referenced by the Netvox LoraWAN Application Command document and http://www.netvox.com.cn:8888/page/index Data report configuration and sending period are as following: Current Change＜... - Page 6 (2) Read device parameters Downlink: 0297000000000000000000 Device returns: 8297003C003C0100000000 (device current configuration parameter) Example#1 based on MinTime = 1 Hour, MaxTime= 1 Hour, Reportable Change i.e. BatteryVoltageChange=0.1V MaxTime MaxTime leeping(MinTime) leeping(MinTime) Wakes up and collects data Wakes up and collects data Wake up and collects data REPORTS 3.6V REPORTS 3.5V...
-
Page 7: Disabletime And Detectiontime
6. Disabletime and Detectiontime If there is to be a person or animal movement detected by the R718PQA within the monitoring range, the reed switch will be triggered, and only when closing is detected within the following 10 seconds, it reports Occupy status = 1;... -
Page 8: Important Maintenance Instruction
the battery hysteresis. 8.Important Maintenance Instruction Your device is a product of superior design and craftsmanship and should be used with care. The following suggestions will help you use the warranty service effectively. • Keep the equipment dry. Rain, moisture, and various liquids or moisture may contain minerals that can corrode electronic circuits. In case the device is wet, please dry it completely.