Table of Contents
Advertisement
SECTION - 6
f.
Description
Sterndrive unit fasteners
16. Return remote control shift lever to the neutral position.
TRIM CYLINDER INSTALLATION
1. Install the trim cylinders on the aft end of the sterndrive unit with hardware as shown.
2. Install the plastic caps by snapping in place.
NOTE: Lubricate all components except plastic caps during installation.
a
Tube Ref No.
3. Install the sterndrive unit serial number decal.
Speedometer Connection
1. Raise drive to gain access to area between gimbal housing and sterndrive, immediately above
the transom end of the anti‑ventilation plate.
2. Align plastic slots on male and female portions and insert.
90-899883183 DECEMBER 2007
Secure the sterndrive to the bell housings using fasteners as shown. Torque the
fasteners to specifications.
a
a -
Locknut and flat washers
b
a -
Aft anchor pin
b -
Bushings
c -
Flat washers
Description
2-4-C Marine Lubricant with
95
Teflon
DRIVE SYSTEM AND ENGINE INSTALLATION
b
7858
b -
Locknut and continuity circuit washer
Nm
lb‑in.
68
b
c d
a
7849
d -
E‑ring clips
e -
Plastic caps
Where Used
Trim cylinder hardware
lb‑ft
–
50
e
Part No.
92-802859A 1
Page 47 / 54
Advertisement
Table of Contents
