Table of Contents
Advertisement
PREDELIVERY PREPARATION AND STORAGE
4. Rotate trim position sender as required to show full DOWN/IN position on dashboard
instrument as shown.
5. Tighten retaining screws and turn ignition key to the "OFF" position.
Drive unit gear lube monitor
IMPORTANT: Oil level in gear lube monitor will rise and fall during drive operation; always check
oil level when drive is cool and engine is shut down.
1. Remove the gear lube monitor cap.
2. Fill the gear lube monitor to the Operating Range (full) line.
Tube Ref No.
Page 8 / 24
a -
Trim gauge needle
b
a -
Retaining screws
b
a -
Gear lube monitor cap
Description
High Performance Gear
87
Lubricant
a
7883
a
7882
b -
Trim position sender
a
7884
Typical
b -
Operating Range (full) line
Where Used
Gear Lube Monitor
SECTION - 9
Part No.
92-858064K01
90-899883183 DECEMBER 2007
Advertisement
Table of Contents
