Table of Contents
Advertisement
SECTION - 6
NOTE: The quick release button on hose fitting must be positioned away from water inlet fitting,
or block‑off plate if equipped. Release button must not contact water fitting or block‑off plate, if
equipped.
2. Position quick release button on hose fitting away from water inlet fitting. Release button must
not contact water fitting.
f
Description
Water inlet fitting bolts
NOTE: The hose must not come into contact with the steering system components or the engine
coupler and drive shaft.
Alternative Mounting of Gear Lube Monitor on Transom
IMPORTANT: The mounting location specified must be above the steering lever on the transom
assembly. Hose must be positioned to avoid moving parts (steering system, engine coupler).
1. Install the gear lube monitor bracket in the specified location and secure with lag screws and
flat washers.
2. Install the gear lube monitor in the bracket. Secure the monitor with the retaining strap.
Power Trim Pump
1. Select an appropriate mounting location (floor or transom) for the trim pump that:
•
90-899883183 DECEMBER 2007
e
Alpha transom
a -
Water inlet fitting
b -
Star washer and screw
c -
90 degree hose fitting
a
b
a -
Bracket
b -
Lag screw and flat washer
Is within length limits of BLACK and GRAY hydraulic hoses coming from gimbal housing
assembly.
DRIVE SYSTEM AND ENGINE INSTALLATION
c
d
d -
Quick release button
e -
ACCEPTABLE positions
f -
NOT ACCEPTABLE position
Nm
5
c
d
7706
c -
Gear lube monitor and cap
d -
Retaining strap
a
b
d
7705
lb. in.
lb. ft.
45
Page 11 / 54
Advertisement
Table of Contents
