Assembly - Vacmaster RESPIRA UC0412EUK Manual

GB
A flat headed screwdriver is required for part of the assembly process.
1. Remove all the contents from the packaging; make sure you have all contents as listed on page 7.
2. Remove the pre-installed screw bolt with a screwdriver or a coin. Insert the handle assembly
into the main body and secure with the screw bolt (Fig. 1).
3. Insert the larger end of the extension wand into the top of the connection hose through the
bracket until the wand is fully seated on the post (Fig. 2).
4. Insert the end of the flexible hose into the main body by aligning the UNLOCKED marks (
Rotate the hose until the marks align with the LOCKED symbol (
the lower hose storage and the upper hose storage. Insert the suction hose end onto the top of
the extension wand (Fig. 3).
5. Insert the combination tool onto the accessory storage post located on the back of the main
body (Fig. 4).
6. Wrap the power cord around the upper and lower cord hooks (Fig. 5).
NOTE: Make sure to wrap the power cord around the upper cord hook first, secure the power cord
into the guide (
7. Secure the plug to the power cord (Fig. 6).
WARNING: Wrapping the power cord too tightly with excessive stress on the cord may
cause damage. A damaged cord is an electrical shock hazard and could cause personal
injury or damage.

ASSEMBLY

).
3
). Run the flexible hose over
2
8
).
1