Advertisement
PRESSURIZED EQUIPMENT HAZARD
Fluid from the gun, hose leaks, or ruptured components can splash fluid in the eyes or on the skin and
cause serious injury.
D Do not stop or deflect leaks with your hand, body, glove or rag.
D Do not point the dispensing valve at anyone or at any part of the body.
D Do not put your hands or fingers over the grease fitting coupler.
D Tighten all fluid connections before operating the equipment
D Check the hoses, tubes, and couplings daily. Replace worn, damaged, or loose parts immediately.
TOXIC FLUID HAZARD
Hazardous fluid or toxic fumes can cause serious injury or death if splashed in the eyes or on the skin,
inhaled, or swallowed.
D Know the specific hazards of the fluid you are using.
D Store hazardous fluid in an approved container. Dispose of hazardous fluid according to all local,
state and national guidelines.
D Always wear protective eyewear, gloves, clothing and respirator as recommended by the fluid and
solvent manufacturer.
General Information
NOTE: Reference numbers and letters in parenthesis
in the text refer to callouts in the figures and the parts
drawing.
NOTE: Always use genuine Graco Parts and Accesso-
ries, available from your Graco distributor.
Grounding
WARNING
FIRE AND EXPLOSION HAZARD
Before operating the pump, ground the
system as explained below. Also read
the section FIRE OR EXPLOSION HAZ-
ARD on page 2.
1. Pump: Connect a ground wire (A) to the pump as
shown in Fig. 1. Connect to the other end to a true
earth ground. Order Grounding Kit (Part No.
222084)
WARNING
Installation
2. Air Compressor: Follow the manufacturer's recom-
mendations.
3. Use only metal or conductive containers.
4. All solvent pails used when flushing, according to
local code. Use only metal pails, which are con-
ductive. Do not place the pail on a non-conductive
surface, such as paper or cardboard, which inter-
rupts the grounding continuity.
Fig 1
A
9247A
308154
3
Advertisement
