Table of Contents
Advertisement
2.2
Rear Panel
[11] POWER switch
[14] FUSE
[11] POWER switch
[12] GPIB connector
[13] RS-232C connector
[14] FUSE
[15] AC inlet
KDS6-0.2TR
POWER
LINE
MARK
VOLTAGE
100
90V-110V
120
10 4V-126V
220
19 4V-236V
240
207V-250V
FUSE
AC LINE
50
/
60Hz 40VA MAX
[15] AC inlet
Fig. 2-2
Turns the power on ( | ) and off (O).
The connector is used to connect the KDS6-0.2TR to a GPIB controller.
For details on setting the address, refer to 4.1.1, "GPIB Interface."
The connector is used to control the KDS6-0.2TR remotely through a computer,
sequencer, or the like using an RS-232C interface. The use of cross-cables enables
communication at a maximum rate of 38400 bps. For information on settings, con-
nection, and other details, refer to 4.1.2, "RS-232C Interface."
This is a fuse holder for input power that also serves as a voltage selector.
For details, refer to 1.4, "Checking the Input Power and Fuse."
This is the connector for the power cord. When plugging in the cord, push it in as far
as it can go.
For details, refer to 1.6, "Grounding."
WARNING
FOR CONTINUED F IRE PROTECTION, REPLACE
FUSE
FUSE ONLY W ITH 250V FUSE OF THE SPECIFIED
TYPE AND RATING.
AC250V
TO AVOID ELECTRIC SHOCK,THE POWER CORD
1A ( T )
PROTECT IVE GROUNDI NG CONDUCTOR MUST
AC250V
BE CONNECTED TO GROUND.
0.5A ( T )
DO NOT REMOVE COVERS, REFER SERVICING
TO QUALIFIED PERSONNEL.
GPIB
SH1 AH1 T6 TE0 L4 LE0 SR1 RL1 PP0 DC1 DT0 C0 E1
[12] GPIB connector
RS232C
[13] RS-232C connector
Names and Functions of Parts 17
Advertisement
Table of Contents
