Front Panel; Panel Description; Rear Panel - Kikusui PWX Series Quick Start Manual

n

Panel Description

Front Panel

[Rack mount bracket]
[POWER switch]

Rear Panel

[RS232C]
RS232C port for controlling
the PWX series remotely
[USB]
USB port for controlling
the PWX series remotely
[Sensing terminal connectors]
Ter minals to connect the
sensing cables
n
Dimensions/Rack Mount
n PWX750ML (Half Rack size)
n PWX750LF, PWX750MLF
PWX1500L, PWX1500ML
[PWR DSPL key]
Used to display the output power on
the ammeter (the key has an LED).
[CURRENT knob]
Used to set the current value or select a
parameter number in the CONFIG settings.
[Air inlet (louver)]
Air inlet for cooling
[OUTPUT key]
Used to turn output
on and off.
[LAN]
Ethernet port for controlling
the PWX series remotely
[J1]
External control
connector
[Option slot]
Slot for installing an
optional interface board
(factory option)
[LOCAL key]
Used to switch between local mode
and remote mode (the key has an LED).
[SET key]
Used to set and confirm the
out put vol tage and output
current (the key has an LED).
[Chassis terminal]
Connector for grounding the output
[DC OUTPUT]
Output connector
[AC INPUT]
750 W type: AC inlet
Thin & Wide range
PWX series
[SHIFT key]
Used to enable the functions that are
written in blue characters below the key.
[VOLTAGE knob]
Used to set the voltage value or change
the value of a CONFIG parameter.
[CONFIG key]
Used to configure the various operating
conditions (the key has an LED).
[OCP, OVP keys]
Used to set and display the overcurrent protection
(OCP), overvoltage protection(OVP), undervoltage
limit (UVL) trip points (the key has an LED).
[AC INPUT]
1500 W type: input terminal
p750 W type
9