Stihl KM 111 R Instruction Manual page 4

English
3.2 Transporting the Power Tool
Always shut off the engine.
Transporting by vehicle: Properly secure your
power tool to prevent turnover, fuel spillage and
damage.
See also notes on "Transporting the Machine" in
the instruction manual of the KombiTool you are
using.
3.3 Fueling
Gasoline is an extremely flammable
fuel. Keep clear of naked flames. Do
not spill any fuel – do not smoke.
Always shut off the engine before refueling.
Do not fuel a hot engine – fuel may spill and
cause a fire.
Open the fuel cap carefully to allow any pressure
build-up in the tank to release slowly and avoid
fuel spillage.
Fuel your power tool only in well-ventilated
areas. If you spill fuel, wipe the machine immedi‐
ately – if fuel gets on your clothing, change
immediately.
After fueling, tighten down the fuel
tank cap as securely as possible.
4
3 Safety Precautions and Working Techniques
This reduces the risk of unit vibrations causing
the fuel cap to loosen or come off and spill quan‐
tities of fuel.
To reduce the risk of serious or fatal burn inju‐
ries, check for fuel leakage. If fuel leak is found,
do not start the engine.
3.4 Before Starting
Check that your power tool is properly assem‐
bled and in good condition – refer to appropriate
chapters in the instruction manuals.
– Check the fuel system for leaks, paying spe‐
cial attention to visible parts such as the tank
cap, hose connections and the manual fuel
pump (on machines so equipped). If there are
any leaks or damage, do not start the engine –
risk of fire. Have your machine repaired by a
servicing dealer before using it again.
– Use only an approved combination of cutting
attachment, deflector, handle and harness. All
parts must be assembled properly and
securely.
– The stop switch must move freely.
– Check smooth action of choke knob, throttle
trigger lockout and throttle trigger – the throttle
trigger must return automatically to the idle
position. The choke knob must spring back
from the g and < positions to the run posi‐
tion F when the throttle trigger lockout and
throttle trigger are squeezed.
– Check that the spark plug boot is secure – a
loose boot may cause arcing that could ignite
combustible fumes and cause a fire.
– Never attempt to modify the controls or safety
devices in any way.
– Keep the handles dry and clean – free from oil
and dirt – for safe control of the power tool.
– Adjust the harness and handle(s) to suit your
height and reach.
To reduce the risk of accidents, operate your
power tool only if it is in a safe condition.
If you use a shoulder strap or full harness: Prac‐
tice removing and putting down the machine as
you would in an emergency. To avoid damage,
do not throw the machine to the ground when
practicing.
See also notes on "Before Starting" in the
instruction manual of the KombiTool you are
using.
3.5 Starting the Engine
Start the engine at least 3 meters from the fuel‐
ing spot, outdoors only.
0458-436-0121-B