Chore-Time PigTek PT1023 User Manual page 8

4. Align the Automatic Bin Slide's mounting rails over the transfer plate, making sure the
slide(s) are properly engaging the tracks inside the transfer plate. Use the lower boot
hardware to fasten the Bin Slide's rails to the transfer plate (hardware may need to be re-
placed if it is in poor condition).
5. Once fastened, check once more that the slide is moving smoothly from the bin slide's
rails to the transfer plate's rails by manually rotating the shaft.
6. Wire up the motor(s) to control using the circular connectors provided. Operate unit open
and closed to make sure adequate limits are reached.
7. (Optional) if leaks occur between upper boot/transfer plate, check for full engagement of
fasteners. Otherwise, apply caulking or similar patching compound in between joints.
8
Figure 5: Mounted bin slide
Figure 4: Mounting posi-
tion of a typical Automatic
Bin Slide
PTM007