Table of Contents
Advertisement
3.8 Load BIOS Defaults
BIOS defaults indicates the most appropriate value of the system parameter which the system would be
in minimum performance. The OEM manufacturer may change the defaults through MODBIN before
the binary image burn into the ROM.
3.9 Load Setup Defaults
Chipset defaults indicates the values required by the system for the maximum performance. The OEM
manufacturer may change to defaults through MODBIN before the binary image burn into the ROM.
3.10 Password Setting
Change, set, or disable password. It allows you to limit access to the system and Setup, or just to Setup.
When you select this function, the following message will appear at the center of the screen to assist you
in creating a password.
ENTER PASSWORD:
Type the password, up to eight characters, and press <Enter>. The password typed now will clear any
previously entered password from CMOS memory. You will be asked to confirm the password. Type
the password again and press <Enter>. You may also press <Esc> to abort the selection and not enter a
password.
To disable password, just press <Enter> when you are prompted to enter password. A message will
confirm the password being disabled. Once the password is disabled, the system will boot and you can
enter Setup freely.
PASSWORD DISABLED.
If you select System at Security Option of BIOS Features Setup Menu, you will be prompted for the
password every time the system is rebooted or any time you try to enter Setup. If you select Setup at
Security Option of BIOS Features Setup Menu, you will be prompted only when you try to enter Setup.
IDE HDD Auto Detection
3.11
Automatically configure hard disk parameters.
Save & Exit Setup
3.12
Save CMOS value changes to CMOS and exit setup.
35
Advertisement
Table of Contents
