Pine Technology PT-730A User Manual page 44

3C Setup Enabled
3D Initialize
Mouse
3E Setup Cache Controller
3F Reserved
BF Chipset Initialization
40
41 Initialize Floppy Drive
& Controller
42 Initialize Hard Drive &
Controller
43 Detect
Serial/Parallel Ports
44 Reserved
45 Detect & Initialize Math
Coprocessor
46 Reserved
47 Reserved
48-4D Reserved
4E Manufacturing
Loop
Messages
4F Security Check
50 Write CMOS
51 Pre-boot Enable
52 Initialize Option ROMs
53 Initialize Time Value
60 Setup Virus Protect
61 Set Boot Speed
62 Setup NumLock
63 Boot Attempt
B0 Spurious
B1 Unclaimed NMI
E1-EF Setup Pages
FF Boot
& Install Detect if mouse is present, initialize mouse, install interrupt
vectors.
Initialize cache controller.
Program chipset registers with Setup values
Display virus protest disable or enable
Initialize floppy disk drive controller and any drives.
initialize hard drive controller and any drives.
& Initialize Initialize any serial and parallel ports (also game port).
Initialize math coprocessor.
POST Reboot if Manufacturing POST Loop pin is set. Otherwise display
or Display any messages (i.e., any non-fatal errors that were detected during
POST) and enter Setup.
Ask password security (optional).
Write all CMOS values back to RAM and clear screen.
Enable parity checker
Enable NMI, Enable cache before boot.
Initialize any option ROMs present from C8000h to EFFFFh.
NOTE:
C8000h to F7FFFh.
Initialize time value in 40h: BIOS area.
Setup virus protect according to Setup
Set system speed for boot
Setup NumLock status according to Setup
Set low stack
Boot via INT 19h.
If interrupt occurs in protected mode.
If unmasked NMI occurs, display
Press F1 to disable NMI, F2 reboot.
E1- Page 1, E2 - Page 2, etc.
When FSCAN option is enabled, will initialize from
44