Pine Technology PT-730A User Manual page 25

Boot Up NumLock Status
On
Off
Boot Up System Speed
It selects the default system speed - the speed that the system will run at immediately after power up.
High
Low
IDE HDD Block Mode
Enabled
Disabled Disable IDE HDD Block Mode
Gate A20 Option
Normal
Fast
Memory Parity Check
Enabled
Disabled Ignore memory parity check
Typematic Rate Setting
This determines the typematic rate.
Enabled
Disabled Disable typematic rate
Typematic Rate (Chars/Sec)
6
8
10
12
15
20
24
30
Keypad is number keys
Keypad is arrow keys
Set the speed to high
Set the speed to low
Enable IDE HDD Block Mode. The BIOS will detect the block size of
the HDD and send block command automatically
The A20 signal is controlled by keyboard controller or chipset hardware
The A20 signal is controlled by Port 92 or chipset specific method
Normal memory parity check. System DRAM is no parity bit then the
system will display "RAM parity error"
Enable typematic rate
6 characters per second
8 characters per second
10 characters per second
12 characters per second
15 characters per second
20 characters per second
24 characters per second
30 characters per second
25