Rennsteig 815130 Manual page 16

Owner's Manual Tools for Processing Polymeric Optical Fiber (POF)
D.)
Stripping unit with fixed stop, cable
groove 2, upper and lower stripping
blade
Crimp unit with
crimping die and
locator
Clamping device to lock in crimp
contact
E.)
Cable groove 2
Cable groove 1
with integrated
stop
Rev.: 2017-03-13
Cable groove 1
Upper/ lower Stripping
blade
· Place the cable into the cable groove 1 for cutting, now close the tool
handles until you hear the last ratcheting sound.
· Pull lever (not shown in picture) in the direction of the arrow until the
cut has been made.
· Push lever back to it's original position.
· Close the plier handles until you hear the last ratcheting sound, so
that the automatic locking mechanism is released and the tool opens
by itself.
· Place cable in cable groove 2 of the stripping area, clear up to the
fixed stop.
· Close the tool handles until you hear the last ratcheting sound. Now
release the handles very slightly (DO NOT OPEN) and pull out the
cable sideways and straight.
· Close the plier handles until you hear the last ratcheting sound, so
that the automatic locking mechanism is released and the tool opens
by itself.
· Remove cable from cable groove 2.
· Remove, if necessary, some insulation residue left behind with an
appropriate tool from the cable groove 2 of the stripping aid.
· Place the Toslink F05 connector to be crimped into the connector
intake and turn the clamping device to 90°.
· Place prepared POF-cable into the connector clear up to the stop.
· Close the plier handles until you hear the last ratcheting sound (Tool
will open automatically by itself).
· Remove crimped connector..
· Place cable into the cable groove 2 of the stripping device (select a
stripping length of 12 mm minimum).
· Close the tool handles until you hear the last ratcheting sound, so that
the cable is cut accurately.
· Release the handles very slightly, but DO NOT open completely and
pull out the cable sideways and straight.
· Close the plier handles until you hear the last ratcheting sound, so
that the automatic locking mechanism is released and the tool opens
by itself.
· Remove the cable from the cable groove 2.
· Remove, if necessary some insulation residue left behind with an
appropriate tool from the cable groove 2 of the stripping aid.
· Place the cable for cutting into the cable groove 1 up to the
integrated stop and close the tool handles until you hear the last
ratchetig sound.
· Pull lever in the direction of the arrow until the cut has been made.
· Push lever back to it's original position.
· Close the plier handles until you hear the last ratcheting sound (Tool
will open automatically by itself).
· Remove cable.
EN
7 / 9