GRAPHTEC Craft ROBO CC200 User Manual page 5

PREFACE
PREFACE
CONTENTS
CONTENTS
1.2 Craft ROBO Parts and Functions
Craft ROBO (CC200)
Cutting mat
Guideline
Feed knob
Cutting head ................. Drives the blade holder/pen holder to the left or right
Clamp bracket .............. Holds the blade holder/pen holder and drives it up or down
Standby switch ............. Turns the power supply to the Craft ROBO on and off. When the power supply is
Feed knob ..................... Used to manually feed the media back and forth
USB interface connector
............................. Used for connecting the USB cable
AC adapter jack ............ Used for connecting the AC adapter cable
Cutting mat ................... Cutting or plotting is performed on this surface
Pinch rollers ................. Hold the media in place against the media rollers
Media rollers ................. Move the media back and forth
Front guide ................... Used as the work surface
Guideline ....................... Used as a guide when media is loaded
1-2
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Media roller
on, the switch's lamp lights blue.
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
Appendix A. Standard Specifications
Appendix A. Standard Specifications
Pinch roller
Clamp bracket
INDEX
INDEX
Cutting Head
Front guide
Standby switch
AC adapter jack
USB interface connector
CHAPTER 1. PRIOR TO USE