GRAPHTEC Craft ROBO CC200 User Manual page 21

PREFACE
PREFACE
CONTENTS
CONTENTS
CHAPTER 3. CRAFT ROBO CONTROLLER
The Craft ROBO Controller is a program that is used to perform all the basic settings such as selection of the
Media Type and Craft ROBO operations such as test cutting.
CHECKPOINT
The term "media" as used in this manual refers to paper, film, and other materials to be cut or printed
on.
3.1 System Requirements
The minimum system requirements to run the software are as follows.
• OS: Windows 2000, Windows XP or Windows Vista
• CPU: Pentium III 600 MHz or better
• Memory: 128 MB minimum (256 MB recommended)
• Monitor: Must be capable of 1024 x 768 High Color display (True Color recommended)
• Mouse
• CD-ROM drive
Caution
CHAPTER 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
When using Windows Vista/Windows XP or Windows 2000, be sure to log on using an
account with Administrator rights.
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
Appendix A. Standard Specifications
Appendix A. Standard Specifications
INDEX
INDEX
3-1