GRAPHTEC Craft ROBO CC200 User Manual page 13

PREFACE
PREFACE
CONTENTS
CONTENTS
Using the carrier sheet for media from 191 to 210 mm in width (equivalent to ISO A4 size)
CHECKPOINT
(1) Peel off the inside liner and the liner strips on both sides of the carrier sheet, so that the entire
adhesive surface is visible.
(2) Press the media onto the adhesive surface of the carrier sheet.
CHECKPOINT
2-8
CH 1. PRIOR TO USE
CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
CH 2. CONNECTION AND PREPARATION
Do not use media that is wider than 210 mm with the carrier sheet.
Liner
Peel off the inside liner and the liner strips
on both sides of the carrier sheet.
• When pressing the media onto the adhesive surface, be careful not to cause air
bubbles or wrinkles in the media.
• Make sure that all of the media is pressed down.
• Make sure that the edges of the media are parallel to the edges of the carrier sheet.
Media
CH 3. CRAFT ROBO CONTROLLER
CH 3. CRAFT ROBO CONTROLLER
Appendix A. Standard Specifications
Appendix A. Standard Specifications
Adhesive surface
Carrier sheet
CHAPTER 2. CONNECTION AND PREPARATION
INDEX
INDEX