SRAM Rockshox Reverb AXS XPLR 2022 Service Manual page 42

12 Confirm the poppet valve is installed. Check your work area once Confirm the poppet valve is installed. Check your work area once
more and confirm the poppet valve is installed before pressurizing more and confirm the poppet valve is installed before pressurizing
the seatpost. the seatpost.
The poppet valve must be installed at this step. Failure to install the
poppet valve will cause permanent damage to the seatpost if it is
pressurized without the poppet valve installed.
Pressurize the seatpost to the rider's total weight (lb), including riding
gear, times two.
Rider's total weight (lb) x 2 = Seatpost air pressue (PSI)
Example: 200 lbs x 2 = 400 PSI
Decrease air pressure as desired to increase compliance when the
post is lowered less than full extension. See the Reverb AXS / Reverb
AXS XPLR User Manual for more details.
To avoid permanent damage to the seatpost, do not pressurize less
than 200 PSI, or more than 500 PSI.
13 Install the air valve cap finger tight.
14 Remove the seatpost from the vise.
Clean the entire seatpost.
NOTI CE
NOTI CE
Shock pump ≥200 PSI - ≤500 PSI
9 mm
42
Air Assembly Installation