SRAM Rockshox Reverb AXS XPLR 2022 Service Manual page 41

9 Confirm the poppet valve is installed and that it is NOT engaged Confirm the poppet valve is installed and that it is NOT engaged
completely into the air piston before installing the o-ring. completely into the air piston before installing the o-ring.
Insert a new bottom out o-ring into the lower post. Gently push the
bottom out o-ring down until it rests on top of the air piston. Confirm
the bottom out o-ring is installed flat and square onto the air piston.
Do not contact or push the poppet valve down when installing the
bottom out o-ring.
The poppet valve must be installed at this step. Failure to install the
poppet valve will cause permanent damage to the seatpost if it is
pressurized without the poppet valve installed.
10 Apply grease to a new air cap assembly o-ring and install it onto the air Apply grease to a new air cap assembly o-ring and install it onto the air
cap. cap.
11 Confirm the poppet valve is installed before installing the air cap. Confirm the poppet valve is installed before installing the air cap.
The poppet valve must be installed at this step. Failure to install the
poppet valve will cause permanent damage to the seatpost if it is
pressurized without the poppet valve installed.
Thread the air cap assembly into the lower post and tighten it.
Wipe away any excess grease.
NOTI CE
NOTI CE
SRAM Butter Grease
24 mm 25 N•m (221 in-lb)
41
Air Assembly Installation